Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Expert team- Looking for your support to find the way to list down all the active endpoint IP address in the a command line. We are in the process of DC migration. Need to know the remaining active endpoint IP address in the fabricregards...
Hello All - ACI is integrated with VMWare vCenter.In ACI, Under Operational--> Client End-Points, the three values is little confusing. Can you help me to understand what it means. What is the difference between them? - vmm - learned, vmm - learnedr...
Hello - Can you help me understanding what is "Route Installed" and "Nexthop Override" in "show dmvpn" command
Device# show dmvpnLegend: Attrb --> S - Static, D - Dynamic, I - IncompleteN - NATed, L - Local, X - No SocketT1 - Route Installed, T2 - N...
Hello - I am aware "bandwidth" interface command is for Higher level protocols to take routing decision. Also how it influence the tx/rx load calculation (TX Load = Output rate / Bandwidth command set * 255)
I have a typical scenario.
interface Tun...
Hello Chris - Thank you very much for responding with a detailed excellent explanation. Very Helpful. I am taking this chance to appreciate and thank you for your blogs in https://rednectar.net/ especally ACI contents. It is the first go to place to ...
Thanks Robert - It is nice explanation which i should record it for my quick reference. Your reply is very helpful. Sorry for not replying on the same day you posted the answer. Thanks again
