Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Cisco,I have two Cisco RV8082 Routers which I would like to setup a VPN Tunnel with Gateway to Gateway. One location is a static IP Address. The other location is a dynamic IP address.Can someone let me know if this is setup is possible.Can some...
Cisco,Is there any movement on this? I am experincing the same issue. There is no way that i know of to downgrade vesion 2.0 firmware back to version 1.0. I am using a RV082 V02 hardware model.DNS queries are very slow with the latest firmware 2.0...
That is good that things eventually worked out for you. I also think the 100Mbps is a limitation that I should eventually address on our network.In the end, the small D-Link router running DD-WRT did not have enough memory to make the PPTP speeds on...
Hi Sheldon,After a full day of trying different firmwares, reseting the router to factory defaults, and switching them out between the two units that I have, I have finally decided to scrap the routers as well. Too bad too, because they can be great...
I am experincing the same problem as the original poster.I have: RV082 V2 (latest firmware: 2.0.2.01).My Mac machines are all experincing very slow internet. A lot of the times it just times out completely and the page wont load. My windows machin...
