Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently use a WGB352B configured to attach to an AP1231G for a remote buildings connectivity. The buildings are about 1200-1500 feet apart. I have Yagi antenna's on each side. Signal quality typically ranges 70-80%, but strength is between 30-...
Bill, When I acquired the 1231's, I knew I would need to update the IOS. I was right. All three are running on 12.3(8)JA2, which looks like the most current on Cisco's website. Can you confirm?Not sure about your other suggestion. The AP is confi...
Bill, I have finally acquired a couple of 1231's. Both appear to be working normally. I have one in AP mode, and the second in WGB mode. The AP is working great. The WGB however "bounces" when connected. There are four messages that repeat withi...
Bill,Thanks. The 1231 would improve the speed, but the performance is worrying me more. The strength in is about -76dBm. I find the bridge tool next to useless. To start the products I have are not in the tool. I'm measuring things in feet, not ...
