Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Do you know if it is possible to setup a PAP2T to automatically dial a particular number or extension? We have a scenario where we have a lobby phone. It is an Analog Phone connected to our VoIP PBX. I'd like to have the PAP2T force the extension t...
These are Cisco 504G Phones running 7.4.9 and/or 7.4.8 SIP.Here is our issue:A call comes into the main reception desk, it is for Ext 101. The process for the user is to call *9 101 and activate the intercome and announce the call using the *9 featur...
These are Cisco 504G Phones running 7.4.9 and/or 7.4.8 SIP.Here is our issue:A call comes into the main reception desk, it is for Ext 101. The process for the user is to call *9 101 and activate the intercome and announce the call using the *9 featu...
I am trying to have the Intercom Intro Page Tone to be louder. I think I have found where to change it - in the Call Progress Tones Section, under PAGE TONE....BUT...I do not have any clue what to change the variable to?!The Page Tone Default Setting...
I am trying to create a script on a UC540 that we can take offline and make changes to. We have been able to create this from within CCA – Auto Attendant but am not able to locate the script for download, after building changes into it. Is it saving...
We ran into this quite some time ago...it was clear that is was an issue with the Firmware Upgrade / Upgrade Enable of the phone. It periodically checks for either Firmware Updates...and goes through a boot cycle when it does...Changing the Firmwar...
Nice thought...BUT....As expected, it no longer automatically activates the speaker enabling the caller to make an annoucement when there are NO active calls...It does work in the scenario described though...it prevents the interruption of the CURREN...
This is not connected to a UC5xxThis is connected to a 3CX Commercial PBX.I have already been in touch with 3CX Support, as well as developers. I can assure you through WireShark Packet Captures, this is a Cisco Phone (504G in this case) issue. The...
