CME 12.0 on 2921 with 7800 &7945 unregistered after GW reload. Configs still the same.GW load: c2900-universalk9-mz.SPA.157-3.M8.binLoad 7841 is sip78xx.14-0-1-0001-135IP dhcp binding showing IPs for the phone but voice register pool all bri only sho...
Forum Posts
Hello,Within the past few months, we integrated SPA 303 phones within our small team. I am looking to configure 3 of these devices (as I am the admin) to monitor the status of each other. There is the following section from the user manual, however, ...
Hello,I'm posting this message to report a software regression that affects the "11.2.4" (ATA19x.11-2-4MPP0001-115) firmware version of the ATA191-MPP.Affected versions and configuration: The issue is encountered when using IPv6 only network for SIP ...
Dear all, I'm new to the community and never ask question before. Please forgive me if questions are not proper way. My Question I'm planning to deploy VG410 with FXS for analogue phones and have to integrate existing CUCM 12.x. Is it any technical r...
Cisco IP Phone CP-8861 WebUI admin passwordUnable to log in writes incorrect password even after resetting all settings or factory reset, I tried both admin admin and user userIncorrect user name and/or password. Please try again.
We have finished relabeling posts for supported products in the Voice Systems and Accessories board. The read-only mode that was active from February 20th to April 3rd is now completed. This initiative aims to enhance your experience by making it eas...
Yesterday I changed from ATT to Time Warner Cable not my Cisco SPA504G phone will only receive calls. When I call out it rings but the person on the other end of the phone can not hear me and I can't hear them. Does anyone know how to fix this? Time ...
I am trying to get a 9871 (also tested on 8865) phone to subscribe to an Event List for BLF hosted on an Asterisk based PBX. I followed the instructions here...https://www.cisco.com/c/en/us/support/docs/smb/collaboration-endpoints/cisco-ip-phone-7800...
Hello Cisco community I recently purchased six 8861 Cisco phones from Amazon 2 of the devices requiring the license activation code, and the seller is not providing them, I reached out to Cisco they said the customer is not affiliated with them, is ...
The SPA962 with the latest firmware (6.1.3a) exhibt an issue with the back light timer. I can set the time in the Preference>Back Light Timer and save the setting. However, if I check it again the value (i.e. 10, or 30..) it's not there. Also "Screen...
I am unable to set a backlight timeout on my SPA 962. I have heard this was an issue with the latest firmware, but there has never been a newer version released.Does anyone know how to fix this? Or perhaps know of a workaround, other than using the s...
how to change the display name on the cisco 303 phone
Good afternoon,I’m hoping to get some assistance. I’ve spent hours searching for a solution but haven’t been able to find what I’m looking for. I understand the 7965G is quite old, but I’m simply testing with it. I made a mistake when I entered the c...
I enabled SNR on a users line. Works fine.Customer does not like that other phones show the option under CME Services URL>My Phone APPS> Single Number Reach, even when the phone line is not programmed to allow SNR. Is the SNR option something that ...
We are trying to eliminate the user's ability to create their own greetings. Looking for something like:"Sorry (users name from the Display Name/robotic voice) is not available, record your message at the tone. When you are finished, hang up or pr...