Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My setup is basic with ap-manager and management interfaces both untagged and two dynamic interfaces on VLANs 1 and 2. The WLC2106 is connected to a L3 C3560 through a dot1q trunk native VLAN 4. Ap-manager and management interfaces are managed from V...
I have a WLC4402 connected to 2950 switch trunk port. The switch has 3 VLANs 300, 400 and 500. The AP Manager and Management interfaces are tagged on 500. I am using a 2600 router on a stick also connected to the 2950 through another trunk. The AP Ma...
I really would like to avoid any solution that requires creating additional subnets. If all fails I'll have to set up different subnets for wired and wireless clients. I just wanted to get absolute confirmation that wired & wireles clients can't be o...
Brad, routing is already enabled on C3560. Actually according to docs I've seen (& packet capture on trunk) when you ping a device on the wired LAN from the WLC, the source address is that of the dynamic interface. So it means there is really no rou...
Hi Scott, thanks I got it to work. I still can't figure out how to make the WLC work with the ap-manager and management interfaces tagged. For now it's not too important but I'll revisit it later. Cheers
Thanks, I'll try this. But I'm just wondering, if I set the AP Manager and Management interfaces as 0 (untagged) then I've no need for VLAN 500? I was trying to follow the recommendation "Cisco recommends that only tagged VLANs be used on the control...
