Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have tried in vain to set this firewall up right so that i can get on the internet but have so far failed. It is replacing an old Symantec Firewall which had the settings i thought i would need in. I have put the settings into this firewall but i...
I have just got a PIX 506E and i turned off the DHCP server for the inside address and assigned it an ip of 125.0.0.57 and a subnet mask of 255.255.0.0 so it can work on the network. However i might have typed the subnet mask in wrong as i can no lo...
I tried your commands but it kept saying that range already exists. I have also tried something out of the Cisco manual which although i still can't get on the internet i can now Telnet to my router which i couldn't do before. The command i put in ...
Here is what comes out of mine (just worked out how to do it) not much difference but there is the odd one or two things. Anything obvious to you?PIX Version 6.3(4)interface ethernet0 autointerface ethernet1 autonameif ethernet0 outside security0nam...
It is LAN--Switch--PIX--Router.The config put in in the wizard is as follows:Pix Host Name: pixfirewalldomain:ciscopix.comOutside Interface Config:Speed: AutoStatic IP Address:x.x.x.105Subnet Mask: 255.255.255.252Gateway: x.x.x.106VPN and AutoUpdates...
I didn't know there were limits on the ip addresses. What do you mean by "HTTP x.x.x.x 255.255.255.255 inside" configured?How do i console into the pix (what do i use as the terminal emulation software as the cisco manual isn't clear?
