Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Using ACE to offload SSL, where the ACE talks to the client over SSL and then talks to a couple of SAP WebDispatchers (WD) on HTTP. All setup and working except for a niggling issue. Basically the WD see the request from ACE on HTTP and build some d...
Running 3.1(3)Inter-chasis failoverActive/Standby multi context mode on FWSM.Trying to add a secondary FWSM into a inter-chasis switch config to active as standby unit. Setup primary FWSM and fail over lan link no issues. However on Secondary FW af...
Running FWSM 3.1Need some advise on how I perform a static NAT and then Globally NAT the source address. Basically, I need to provide the following NAT10.1.1.1 -> 10.1.2.1..where 10.1.1.0 is the outside and 10.1.2.0 is the inside. However, I'm rout...
Hi all,We have recently had a problem with a number of 2950 switches (various models/IOS) where on occasion our monitoring stations, which run various software and sit in different locations/subnets, will lose polling contact with the switch manageme...
Hi Roble,Any info/config that you have would be very useful. The sap guys say the can get the ClientProtocol setting work via Apache as a reverse proxy, without the need to change the SAP end, but I think they are looking to push the burden! If you...
