Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We have a 5555-x with multiple interfaces. Our Outside interface and DMZ interfaces have routable IP addresses and DMZ subnet is routed via IP address of the outside interface.
Stripped for readability.
interface GigabitEthernet0/0nameif o...
Hello,we have a setup where our monitoring box has to go through a linux box to get to 3560 to get snmp data, so i have a DNAT setup.For some strange reason snmpwalk always times out on the same spot. Right afterIF-MIB::ifHCOutBroadcastPkts.10152 = C...
Hello,I recently got my hands on an old 515 (128Mb RAM/16Mb Flash)that was running 5.2. I successfully upgraded that to 6.2(4), but then decided to put 8.0(3) on it, to make it more "user-friendly" since i am more familiar with the new ASA5500 family...
Hello,I have spent an entire day trying to figure this out, but have to ask for help.Here is my setupoutside 10.10.6.243 (10.10.6.240/29)newdmz 10.10.33.163 (10.10.33.160/27)olddmz 10.10.9.65 (10.10.9.64/28)provider has following set on their ro...
yes, you can, however, i just came across a weird problem where with foundry switches, if both sides are set to 100/full catalyst loses connectivity, so you have to have both ends on auto/auto.
Ok, problem solved!for the future reference, in case someone has the same problem here is the solution:Go here: https://tools.cisco.com/SWIFT/Licensing/PrivateRegistrationServletAnd request yourself a new key. For some reason when i requested Version...
Yep, i ran show version, but as you can imagine i did not save the output We do have a corporate account with Cisco, so maybe they will able to help...thank you very much for your response,igor
Gentlemen,This issue has been resolved and I fee like a complete idiot It was a missing ACL, which i was sure I put in there earlier in a day, but i guess i ended up pasting the old one back in.
