Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi EveryoneI have an issue with an ASR 1001. The problem occurs with MQC shaping applied to a gigabit interface in the outbound direction. The CIR of the provider we are using is 100Mb/sec, so we are shaping to that value. However when reported traff...
HiYour config is ok except for;Router Binterface GigabitEthernet1/0standby 1 ip 171.16.6.100 However the config may not meet your requirements as the tracking only monitors the physical router interface, so if there is a switch etc between router A/B...
