Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a IR829 rugged router and trying to setup an IP Camera that will be accessible through a cellular connection. I have the cellular interface 'cellular 1/0' connected with a static IP/AT&T SimCard and can ping to the outside. I have a DNS server...
Hello,
I'm trying to get my static IP from AT&T (that we already bought) onto my router (IR829) but when I configure the cellular 1/0 interface, it will not pull in this static IP. I tried both manually setting it to the static IP, but that doesn't a...
I'm trying to setup this IR829 router with an IP camera to be reachable with a cellular tablet. I'm trying to get the cellular part started first and I have a cellular connection that receives an IP address from AT&T. I can ping to the outside world ...
Hello,I'm new to cisco routers and I am trying to solve an issue. I have an IR829 router with an AT&T sim-card for cellular connection. When I configure the cellular interface and establish a connection, I receive an auto assigned IP address. Wheneve...
It originally was pulling from the ISP but after it powered off and on, it never pulled the APN again so manually doing it was my only option. Thank you everyone!
So for example, I go into the Cellular 1/0 interface and do
shut >> no shut
to have it go down and back up. After this, its assigned an IP from the cellular network.
I haven't looked into EEM Scripts but if it can do the following above, then I'll u...