Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently sent the ios v3 upgrade image to my vxworks WAP via web. Let it sit for approximately 1 hour after per the pdf for the upgrade. Have not been able to get anything out of WAP since. It comes up almost immediately with all leds a solid gr...
O.k.I have gotten the WAP to display the console. However it is the base console with no support of running commands. Just CFLUPNRS options. Doesnt support ? command even. Posts on boot with "testing dram" then this menu. Does NOT attempt to go ...
Tried that also. I have tried the 5 second reset for config info and the 30 sec reset for all. I have actually tried it for like 120 seconds just in case. No communications ..(yes its in right port) either way. Acts like mode(reset) button isnt e...
Another tidbit...While connected via crossover and on the same subnet 10.0.0.x, the connection will stay up for about 30-45 seconds then disconnect/reconnect. Does this cycle indefinately. Like the unit is either trying to enable the port over and ...
