About Everett_Racine

Everett_Racine · 06-24-2015

I am trying to find the command that will allow me to delay a remote device from writing a series of commands to configure the link I am communicating over. Once I write the first 2 commands it will dump the link I am remoting into it with.. Can some...

Everett_Racine · 06-26-2015

Yes knocking down the sight here is a very bad thing. It is what I like to call an RGE (Resume Generating Event). LOL Thanks guys for all the help.

Everett_Racine · 06-26-2015

Thanks Joe I think that will work. although the reboot isn't an option as the link is from the core. It would knock out the sight. thanks again

Everett_Racine · 06-25-2015

Hi Charles, thanks for the info on KRON. Not sure if that will apply to the situation I have as I am not looking to have a task scheduled for each week/day. I am looking to reconfigure a link remotely but know that once I enter the first few lines, o...

Everett_Racine · 05-03-2015

HI Charles, In ROMMON mode the commands to load the OS using tftp are quite different then when the OS is in the machine. use the following example (remember a lot of commands are case sensitive in ROMMON):ADDRESS= 192.168.1.1IMAGE= asa825-51-k8.binP...

Member Since	‎05-03-2015 01:54 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5

User Statistics

User Activity

delaying commands sent remotely

Yes knocking down the sight

Thanks Joe I think that will

Hi Charles, thanks for the

HI Charles, In ROMMON mode