Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I want to configure a multicast network but I'm confused about creating a multicast group.I think that I have to assign a multicast address to a switch interface and then to connect a computer to this interface, isn't it?In the attachment there...
Hello,I've a problem with a Switch Catalyst 2950 and a Router 2620XM.I had configured two Vlan in the switch with the following steps:-Eth0/1 I've connected the router and I've enable trunk-Eth0/3 is connected to internet but if I don't enable trunk ...
Hi Pierre, I have a problem and I think you can help me.I want to realize your same configuration:Multicast Source inside -> Pix -> outside and I use a Firewall Pix with version 6.3.The difference is that between inside and outside there isn't only t...
Hi,I think that I have found the solution : if you lunch vlc with "vlc --ttl 5" command it set the ttl value and so there aren't problems in the streaming in different vlans.The problem wasn't in the router configuration!I'm happy but my work doesn't...
Hello Chris,How can I set ttl at 3?What is it not router config?Now I'll concentrate myself to understand if multicast is rightly set but soon I'll have a look to your streamer.Thank you.
In fact I used command line, following the command in the videolan guide, but the client didn't receive the streaming.The command are the following:- On the server computer vlc /root/VLCpackage/airc.avi --sout udp://233.0.73.29 --ttl 35-On the cl...
About this message... during multicast test I stream file that vlc run.Moreover the ttl is a problem because it can be set only using wizard but someone said me that vlc don't really increase it and always use the default value (ttl = 1).I don't unde...
