Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, i'm confused as to what type of NAT I should use for my PIX515E.Our network is at a colocation, and we deal with websites, and multimedia.So based on that, am I right, that I shouldn't be using PAT?I have assigned external IP's pointing to the...
Hello, i'm confused as to what type of NAT I should use for my PIX515E.Our network is at a colocation, and we deal with websites, and multimedia.So based on that, am I right, that I shouldn't be using PAT?I have assigned external IP's pointing to the...
Hello, I'm configuring a new PIX515E, and i'm a bit confused as to the proper fromat to use with regards to access-list/static command. I see 2 ways of doing things, and they both work... so if someone can explain which is the proper way, I'd appreci...
I'm told by our ISP, that I have 5 subnets, and none of them are on vlans, and I have 2 uplinks configured as hsrp on the "outside" 2950, which then goes into a 515E Is this correct? or do I need to setup vlans?x.x.42.x/29 x.x.43.x/28 x.x.56.x/29x....
Hello.We have a consultant, who's telling us, that we can't have internet access, while we connect to our cisco pix 501.Is this true?And, if its not true (which I believe), can someone point us to the info I need to verify this, and or the command li...
I will! I'm starting to understand.What has me confused, I guess is the "wording".That, if I use 1 IP as my "outside" source, PIX will 'PAT' all internal to external with that 1 ip.I CAN'T do that (PAT), because I have multimedia apps on the server, ...
I just found out from our ISP, that the HSRP is configured elsewhere, NOT on the 2950. So I do appreciate your confirming this!. Here I am, thinking I have to setup vlans, etc for the outside switch!Again, thanks!
Ahhh, so, the HSRP is setup NOT on the 2950, but on the "next hop" switch they have setup. The 2950 only has 1 IP, which is the gateway to the internet for both the 2950 and my firewall...one last question: if I have several subnets, do I have to ent...
thanks for the help. and yes you understood.I have a diagram of our topology from the ISP,and from what I can understand, is that the "config" of the HSRP "might" be done in the OUTSIDE 2950.So, the 515E's outside is connected to the OUTSIDE 2950.I s...
