Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When configuring the Interface MAC address in the the high availability tab on the FMC are these virtual MAC addresses that are created by me or, are these the real MAC addresses of the primary and standby interfaces? Would I use the MAC addresses sh...
Hi Marvin, Thank you in advance for your expert guidance. It is always helpful. Florida has passed HB379, which prohibits students in k-12 from accessing social media on school networks. The issue is blocking social media apps on personally owned-mob...
Hi Marvin,I am preparing to update the FXOS firmware on a pair of 4125s running in a HA pair configuration. I am doing so in response to this field notice -> https://www.cisco.com/c/en/us/support/docs/field-notices/720/fn72077.html My current FXOS ch...
Thank you for your reply Marvin. I had an SSD failure. After I replaced the faulty SSD we had a service interruption until we cleared the ARP table on the router. So i am configuring the virtual MAC addresses to avoid this in the future. Might you kn...
thank you for the quick response, much appreciated. i have previously referenced the same configuration guide. So to clarify per the documentation the MAC address entered to configure the MAC for HA is that of the interface ->Configure Virtual MAC ad...
thank you for posting. i receive an alert in the FMC stating "source_IP_block - Failed to download from https://127.0.0.1/custom_blacklist_md5.html: Not Found (404)" is this file created after the first correlation event occurs, or is there a need t...
