Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, running in multiple mode, and sharing both the inside and outside interface.Each context has it's own ip address etc.The ASA classifies the packet into a context by matching the destination address to one of the contexts.Does this mean that if I ...
Hi, with the ASA running in multiple mode, the 'system' space has config, yet has no ip address. Just wondering what is the best way to back this particular config up.I can backup all my contexts, but as this has no ip address it gets difficult.Thank...
Hi, I have been lucky enough to get my hands on 3 of these devices to install. Great machines !!!!I am having a difference of opionion with the collegue who has designed the solution. He has designed it with 3 Virtual Contexts all using shared interf...
Check this site:http://www.cisco.com/warp/public/556/5.htmlit could be your order of operations, because you are not using cbac on the inside interface, and you have a deny in the acl, it maybe that you are dropping it as it gets natted before the ac...
Not sure what the uses are for the 2 subnets, but you could have one as the physical addressing of the pix, and the other subnet used for nat purposes, so upstream devices would just route that subnet towards the outside interface which is on the fir...
