Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All!I have a 3800i (second hand) and I'm banging my head against the wall with setting up Mobility Express. I was a CCNP back when CLI and IOS were the de facto, and this new era of devices are either too easy or too hard...I've (seemingly) succe...
After reworking a lot of settings, I ran the analyzer again. It led me to the 5GHz radio role being set to DOWNLINK. I also found a Cisco Community post saying that backhaul client-serving needed to be enabled. Well, then I decided to look at the ...
Ok, I've done some learning and got it almost working 100%. Using debug capwap errors enable, I found two issues.First, regardless of any setting anywhere, the AP always sees the CAPWAP messages on VLAN0. So, I set: config interface vlan management ...
I should also mention that the LED is constantly alternating green and red, indicating that it's still associating. But I don't know where to look to see the status or errors preventing association. Andrew
Thanks for that tool! It was insightful! I made some changes (the switchport is trunked as native 11, removed the zone-member statement). Also realized I was considering the WLAN config the place to define VLANs; clearly it's not. The fact that I...
