Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a 1142N which does not join the WLC when connected via a 2960 switch. When I connect a different lap 1142N to the same port on the same switch using the same cables, it does join the lap to the WLC. And when I connect the first lap directly...
Option 43 did the trick.Note: You must use the management interface of the WLAN controller.Complete these steps in order to configure DHCP Option 43 for lightweight Cisco Aironet access points in the embedded Cisco IOS DHCP server:Enter configuration...
Thx all for your assistance so far,I have 2 working AP's connected to my 2960 switches. The third AP does not want to join when connected to the 2960. Even when I disconnect the other 2, it still doesn't want to join. It only joins when connected dir...
