Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys.Everytime I try to launch User Tracking, it shows that it failed to connect to the ANIServer.I've tried restarting the ANIServer which didnt work. I even ran reinitdb.pl (with and without the -restore switch),which still failed. Appreciate any h...
I have 2 PIX machines and I have configured the both of them to send logs to my syslogd. What I would like to know is how do I set up two different log files for each PIX machines? Cheers guys
Hi. I would like to setup a remote router where clients can dial in using their 56k modem. I've read that for this scenario, one would require network module digital modems and network module ISDN BRI. Cisco has announced EoL/EoS for NM digital modem...
I have a Cisco 2811 router with 1 ISDN BRII've tried to set it up to accept incoming modem dial in but only to receive this message.BR0/0/0 **ERROR**: accept_incoming_csm_call: modem problem Bearer capabil...
I would like to find out if it's possible to configure my Cisco PIX 525 to use a secondary internet line from a different provider and perform load balancing. I'm using PIX Version 6.3(1)
I'm only catering for about 10 users (not simultaneously) I was thinking of getting a 4 port NM 4B-ST. Its just that after reading the data sheet, Cisco did not mention about supporting BRI cards with the new PVDM digital modems and said only PRI. Ha...
Hi Leo. This is the authentication part taken from the debug----------------------------------*Mar 19 07:21:40.418: As76 LCP: State is Open*Mar 19 07:21:40.418: As76 PPP: Phase is AUTHENTICATING, by this end*Mar 19 07:21:40.418: As76 CHAP: O CHALLENG...
