Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I purchased the PIX 501 configured for my cable service with default settings. I had no problem with it until I started messing with it. I’m not an IT guy but I thought the default settings were all I needed for my stand-alone computer but was rece...
OK,For whatever reason the console method will not work on either computer. We then hooked it up to a network and found a work around via using network connections, properties, Internet Protocol (TCP/IP), properties and then manually inputting 192.1...
Hello,I have checked both my com ports, both are working fine. I have tried using both ports, same results. I have been using the default settings on the ports of 9600baud, 8 data bits, no parity and 1 stop bit. I am leaving now to test the PIX wi...
That's what I tried to do - all I got was a blank screen with a blinking cursor in the upper left hand corner. I tried unpluging the PIX for 30 seconds and a different rollover cable - still nothing.Do you think the PIX died on me?Joe
