Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear, I got 2 routers 3102 model(EOL -product) and I want to connect as bact to back thro serial ports and I got the 50 pin serial port of the router signal name of the each pin. Pls advice me how to make the cable to connect both the routers Thanks ...
From Chandra Prakash,I have very old 3102 (EOL) Router with 1 serial port and this should be used as DTE only . So pls suggest me how i can use this for me to setup with RAD modem Thanks in advanceChandra Prakash
From Chandra Prakash,I have very old 3102 (EOL) Router with 1 serial port and this should be used as DTE only . So pls suggest me how i can use this for me setup with RAD modem Thanks in advanceChandra Prakash
Dear Viore,Thanks for yr reply,Well U given me the config part of the routers and I search the Hardware of the serial port cables pin diagram to connect as back to back , as these cables not available here Chennai, IndiaThanksCP
Hai Shanky,I want to use with HTU - E1, 2Mbps Rad modem and router side cable is 50 pin D type and modem side is 34 pin Winch type (V.35 interface)Regards,Prakash
Thank u Mr. Pauwen,Pls suggest me, this router has 50 pin serial port and can i use this router in HTU - E1 Rad modem (2 Mbps line ) and lots of available routers are supporting DCE type and what is the restriction with this type 3102 router ?Regard...
