Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is anyone else using HSE to manage their CSS devices?We have HSE 1.9 and I am having trouble when I change a css configuration on the CSS CLI. The HSE does not seem to pick up the change. I have to remove the device from the discovery list and add it...
We have a CSS 11503 at 7.4.2.02.It has a number of L3 Sticky rules.The users or rather their workstations are working 24 x 7.We would like to work out what is the best sticky-inact-timeout value to use so that we can gracefully close a server (weight...
We have CISCOWORKS Hosting Solutions Engine Version 1.9.We use it for SNMP statistics of our CSS 11000 series content switches.Recently we have been considering its use for managing the configurations of the CSS devices, especially simple changes suc...
We have a pair of CSS 11503, one armed configurations running VIP redundancy on a single VLAN with a single virtual router, without ASR.Recently the device that had the Master Virtual Router displayed a problem with TCP port keepalives. Some services...
We have CSS 11503 with 07.20.0.03.I have noticed that if I remove a service from a content rule that is using an advanced-balance method (sticky-srcip), all entries for the rule are purged from the sticky-table, rather than just those for the removed...
Hi,thanks for your interest and sorry for the delay replying....We have recently started trying to use the Configuration facilities on HSE but only after upgrading to 1.9 (with an additional patch).So I have recently done the following and re-tested:...
Gilles,thanks for the response.However, what I am trying to acheive is a little more than see the sticky-entries as they are displayed using the standard show sticky-table command.For Layer three sticky entries even if you filter on IP address, you g...
Gilles,thanks for this. I did not find this bug because I searched for "keepalive" rather than "keepalives", (and there is a spelling mistake in the bug). I will be a bit more thorough next time.Anyway, I am not completely convinced as:The services d...
I am going to attempt to attach the trace which was taken at the L2 Catalyst using NAM data capture, on the port attached to the CSS. We filtered this trace to anything to/from the IP address of the "Service" i.e. 31.248.50.241.The CSS has a single I...
