Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I tried unsuccessully to upgrade a PIX 535 with 6.3(5) to 7.1.1.The PIX erased the old version, but then gave an error message that the upload hadn't worked.I believe I've insuficient memory to try again.I haven't re-booted it yet, but if I do, I bel...
I have a central 3000 Concentrator connected to 2 private LANs. It sits behind an Internet facing PIX which is using NAT to NAT the Concentrators outside IP address to a Public address.The Concentrator is to use an IPSEC VPN to a remote PIX.Do I have...
We have a central router connecting to several remote sites. Central router is configured never to dial out.One of the remote routers has been working ok via a BRI for several months.We then changed it onto a new BRI - all configurations staying the...
I have VPN tunnel setup between my PIX and a client. I have an access-list applied to my outside port to filter incoming traffic:access-list acl-in permit esp host 213.212.11.9 host 213.1.244.11 access-list acl-in permit udp host 213.212.11.9 host 2...
Steve,Thanks for replying.We have already contacted the CO as I'm sure they've set the new BRI incorrectly. I just wanted to get peoples input on the error message.Regards
Hi,I would still expect to see hit-counts, as every packet must be filtered before the tunnel endpoints can form the tunnel.The setup in use is PIX-to-PIX.I have other setups PIX-to-Router, whereby the Router has a similar access-list filtering inbou...
