Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an internal network consisting of several subnets (on different vlans) that all need to access the internet thru a single cisco PIX501. These are the inside networks:192.168.1.0192.168.2.0192.168.3.0The outside network is 192.168.0.0The PIX is...
I have a PIX 501 thru which I need to forward traffic from the outside to two servers on the inside network. My outside address in this case will be xxx.xxx.xxx.xxx and the inside addressing range is 192.168.125.x and I want to allow remote assistan...
Hi, I've seen documentation before on how to set up an IP phone to automatically dial a number when someone picks up the hand piece. But today, I cannot for the life of me find this documentation. Can soneone clue me in to how this is done, or po...
Hello, I am looking to temporarily forward a currently unused DID number on my PRI to an outside (off network) number. Where do I do this? With the router or CCM?Regards,John
Hello, My network spans two buildings and each building was set up to have the data networks on two separate subnets. Building 1 the data network is 192.168.254.0 and building 2 the data network is 192.168.252.0. The networks are on separate VLANs a...
I did get the phone to dial-out automatically, however I wanted to add some information not specifically mentioned in the configuration example.I wanted this phone to dial an outside number. When you create your calling search space, make sure you ad...
Rick, I've thought of that, and I guess I should give it a try. They originally brought in their network seperately for their service, (before I had my cisco equipment installed). They then wanted to make their service accessible from our network...
Eduardo, I believe all of the traffic will be from the 254 network into the 3rd party network. They have a server attached to the same router. Two people on the 254 network will use a client application to get into the 3rd party server.John
Rick, You're right, the 3550-12G doesn't look like it'll do what I need. So let's look at two options here, PIX501 and getting the 3rd party to do their job. I'll be in contact with the 3rd party in the next day or so. In case this does not pan o...
