HI team.I have a query.Please refer to the topology: Local Subnet >>>> ASA >>>> R3(DIST swiitch) >>>> R2(WAN ) >>>> INT router(R1) >>>> ISP >>> Remote router >> Remote hostThere are two VRF configured in WAN router and 3 VRF in DIST switchIPSEC tunne...
I have two ASA running in HA.So usually during HA one will be acting as secondary and one as Primary.That is Primary-active and Secondary -stand by or Secondary-Active and Primary -Standby.I want to change the role and not just the state, how to achi...
I have 3 routers R1, R2, R3 connected within same AS (IBGP).I would like to establish a GRE tunnel between R1 and R3, can someone share me some guide please.
IP add of VPC1 is 192.168.1.10 , VPCS 2 is 192.168.2.10
GRE tunnel is configured between R3 and R4.Tunnel is up and I am able to ping the VPC2 from VPC1 and vice versa, however if I take a capture I couldn't able to see the Tunnel IP being encapsula...
Ohh man, it workedAs per your instruction I configured this.
neighbor <R3 tunnel IP> neighbor <R1 tunnel IP>
After. this I could see the traffic is encapsulated, may I know what was the reason behind this?
I have changed the subnet now(1.1.1.1/24 and 1.1.1.2/24).that OK but why you config BGP in R2 ? >>> but without BGP how the neighbour will be formed?Would you want me to configure static route in r2?The problem is Tunnel is UP and I am able to ping h...
.jpg "VIP Engager"){kind=icon}
.jpg "Hall of Fame Guru"){kind=icon}
