About slt20

slt20 · 12-07-2022

I want to simulate NAT port address translation in cisco packet tracer. The key part of the topology is below. I configure the NAT translation on Router33 (in the red circles) as below: Router(config)# ip nat inside source static tcp 5.2.2.2 2222 4.2...

slt20 · 12-08-2022

the PT file is attached here. Thank you very much!

slt20 · 12-08-2022

Yes, this is a manipulated case where 5.2.2.2 wants to stand for 4.2.2.2 to communicate with the outside world. Here I suppose router33, router34 and router32 are in a same AS, and router33 and router32 are the border router. I configure the same NAT...

slt20 · 12-08-2022

the whole topology is as follows:The packet is from the middle-bottom-server 5.2.2.2 to left-bottom-server 2.2.2.2. The static routes on router33 (that connects 5.2.2.2) include to 2.2.2.0/24 and 4.2.2.0/24, as below: When I only map 5.2.2.2 to 4.2....

Member Since	‎12-07-2022 11:34 PM
Date Last Visited	‎12-14-2022 01:41 AM
Posts	4

User Statistics

User Activity

why does router change the destination port to 0 under NAT

Re: why does router change the destination port to 0 under NAT

Re: why does router change the destination port to 0 under NAT

Re: why does router change the destination port to 0 under NAT