Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Is there any way to change the default TTL on the interfaces of a Cisco 3750.I'd like to setup a TTL of 1 for everything that goes out some interfaces.
Hello,I've just recently been faced with a flood on a 3750 that I can't seem to handle and would greatly appreciate any help offered.I have the following setup:24 interface used out of 48 on a Cisco 3750.The C3750 has unicast storm control which prev...
Hello, I was wondering if anything like ip verify unicast reverse-path was available for the C3750 series of switches.Or if there's any other way to implement ip source checking (other than implementing an ACL per each port or activating source guard...
Hello,I've just recently acquired a cisco 3750 switch and after configuring I noticed the following problem:(The current setup is: cisco3750 - 48 ports/ 24 ports used each in its own vlan and with its own ip address / a trunk port)If I arping from a...
Hello,Is there any way to boot the ios for a catalyst 2900XL switch from a tftp server ?The switch doesn't seem to support directly booting from tftp but I heard something could be done with a helper image of some sort.Sorry if I misplaced the questi...
Hi there,
Can I also bump into this thread?I have a setup that interconnects ACI fabric (Spines) with GOLF routers via BGP-EVPN.Do you know if it’s possible to do inter-tenant VRF leaking but not inside the ACI fabric, rather inside the GOLF router...
Hi,Dumb question from my part and maybe someone can clear it up:)As each vNIC has a failover (uplink failover) shouldn't we define vethernet 1, respectively vethernet 2 on both Nexus?Ex:on bothinterface vethernet 2bind interface eth102/1/32 channel 2...