I am using VLAN2 for management and VLAN3 and above for data. Do I still need to assign an IP address to VLAN1?Many thanks for you helpMark

We have created a new VPN tunnel to a 3rd party site and must NAT the traffic. We already have VPN tunnels terminating on our ASA. I've listed below relevant parts of the configuration. nat (inside) 0 access-list INSIDE_NAT0_OUTBOUNDnat (inside) 1 ac...

I am considering purchasing the following 4510R-E switch items for installation in a new building that will go online shortly.a) 1 x 4510R-E Chassis (WS-C4510R-E)b) 1 x Supervisor Engine 6-E (WS-X45-Sup6E)c) 1 x 24-Port 10/100/1000 Module (WS-X4424-G...

We hare opening a new building that will host our companies main application servers (all except two servers will connect to two catalyst 3020 blade swithces that we are relocating). There will be up to 500 members of staff using Cisco IP phones. Two...

Are there any performance benefit to using fibre transceiver modules rather than the ethernet GLC-T? The cabling distance is only going to be about 5 metres.Many thanksMark