About zakhalid

zakhalid · 03-06-2015

I have to do NAT overload on router. Following is the config, and as long as I source traffic from router interface it will work.. but when traffic is across G0/0 (inside) it will not hit ACL or translate There is no host alive at 10.91.8.1 yet and...

zakhalid · 04-24-2015

it's possible - what type of switch is between router and linux?if it's a direct connection than I have not idea what to check.. maybe the linux host but unlikely. I am glad it's working. It's hard to find what was not working now.

zakhalid · 04-23-2015

I don’t recall if it should say /8. Let’s just tell the router that we are sub-netting and to allow 0 subnets. Add these pleaseconfig tip classlessip subnet-zero Also please post followingsh ip access-listthen if acl INGRESS is not applied to inside ...

zakhalid · 04-23-2015

I just assumed you were having same problem.Step by step.. Let's check if NAT is working.use - sh ip nat translationsPro Inside global Inside local Outside local Outside globalicmp 66.117.96.80:1 10.7.0.1:1 8.8...

zakhalid · 04-23-2015

I just assumed you were having same problem.Step by step.. Let's check if NAT is working.use - sh ip nat translationsPro Inside global Inside local Outside local Outside globalicmp 66.117.96.80:1 10.7.0.1:1 8.8...

zakhalid · 04-20-2015

Add 'no ip route-cache cef' to interface 'inside'

Member Since	‎10-06-2005 06:26 PM
Date Last Visited	‎11-13-2023 11:52 AM
Posts	11

User Statistics

User Activity

NAT overload on router works from inside the router only

it's possible - what type of

I don’t recall if it should

I just assumed you were

I just assumed you were

Add 'no ip route-cache cef'