Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OK, Vista's been out for 6 months now, and while Cisco doesn't list support for Vista with ASDM 5.2x, can anyone tell me if they have successfully loaded and used ASDM on Vista?Am I going to have to upgrade my rather large installation of ASA code ju...
Hello, I have just implemented a 501, and am having a strange issue. Seemingly intermitantly, the inside interface stops responding/passing traffic. I cannot ping the inside interface nor can I pass traffic to the Internet/VPN tunnel. After anywher...
I have the same issue/troubles. I think it may be due to a misunderstanding of the term "management"the documentation refers to management in terms of protocols (http, snmp, etc) and not just administrative access to the NAM. If this is true, then ...
no duplicate IPs. The inside network is actually my lab at home, and right now consists of only three computers and two addressable network devices, one of which is the PIX. Very simple design as it's in its early stages. If I have a constant ping...
thanks for the reply. I had thought of that and manually set the inside interface to 10 half for hub it was connected to, then replaced the hub with a 10/100 switch and set the interface to 100/full. a "show int" shows no errors accumulating on the ...
Good Idea, but the pix isn't rebooting. System uptime is 4 days and my VPN tunnel has been up for 4 days. which corresponds to when I placed it in production on my DSL connection in the lab. I have had a ping going to the inside interface (from insi...
