how do i fix this problemR1(config)#do sh parser viewCurrent view is 'root'R1(config)#parser view SNR-ADMIN superview ^% Invalid input detected at '^' marker
sorry about that the version of cisco packet tracer, I'm kind off practicing, the version isRouter(config)#do sh versionCisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.1(4)M4, RELEASE SOFTWARE (fc2)Technical Support: http://www.c...
the current view is in rootR1#enable viewPassword:R1#%PARSER-6-VIEW_SWITCH: successfully set to view 'root'. R1#conf tEnter configuration commands, one per line. End with CNTL/Z.R1(config)#parser view MANAGERR1(config-view)#%PARSER-6-VIEW_CREATED: v...
