Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.I have one AP AIR-CAP3602I-E-K9 with installed Autonomous AP IOS Software- 15.3.3-JF15(ED). I recently purchased a module 802.11 AC. During the configuration I found out that it is not possible to turn on AC radio in autonomous mode.https://qu...
The access point is in my house. There is no other wifi network there except mine. I want to enable 802.11 AC to increase the network speed for mobile devices operating on the 5 GHz frequency
I understand and know that I need to change the firmware in the access point. My question was if after configuring the access point with the controller and disabling the controller, the access point will still work properly.