Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have 2 x 9200L Catalyst trunked together. My objective is after PC1 has been plug into Port1 of SW1, PC1 cannot be plug into SW2 and violation restrict will be triggered. Is this possible or what am I doing wrong here? PC1 -> SW1 <---Trunk-...
Greetings all, I have a Catalyst 9200 Switch. Would it be possible to immediately send to a Syslog server of MAC addresses of devices whenever they plug into any of the switch ports? I understand this is possible via SNMP traps but is it possible via...
Hi all, I have 2 Switches (Catalyst 9200 & SG-350). Both are connected with Trunk port. I am making SG-350 my root switch running on Rapid-Pvst. Configurations as follows: =====Catalyst 9200=====1) #sh run: spanning-tree mode rapid-pvstspanning-tree ...
@balaji.bandi wrote:SNMP trap is best way to do it, you can just create on remote syslog server listed SNMP traps and do post usage what ever you like to do based on the message.Other option is dump all MAC address table and redirect to syslog, this ...
Hi guys, thank you for your responses. @balaji.bandi my network topology is SG-350 <=======> Catalyst 9200L on Ethernet ports. Both switches are Trunk with the same sets of vlans. =====SG-350=====1) sh vlan Vlan Name Tagged Ports UnTagged Ports...
