Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My device changed to the new-style command and I followed the documentation to configure the new version of dot1x and found that there are no class-map and policy-map commands under configure.Is this related to the switch version, or what else needs ...
hi balaji thanks for your reply, I would also like to know the following questions1, reset the switch to restore legacy mode, but I found that if I trying to remove the dot1x configuration on the port causes a direct mode switch, is there a way to s...
hi balaji here is the information you needSW05-01-IDF#show versionCisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(7)E5, RELEASE SOFTWARE (fc3)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2021 by Cisco...
