Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need a sanity check to make sure I am doing this correctly. I have a PIX 515 with two networks. one network is translated to the outside interface (PAT). However, the hosts on the other network CANNOT be nat'ed. So I have static translations s...
I am having translation issues, have tried upgrading to 7.0, then went back to 6.3, all because of NAT.I have the following setup: switch connects to Eth1 on PIX, PIX Eth0 goes out to border router. We have two networks, that need to go out to the ...
have tried just about everything to get my inside users to get traffic back through this pix, but no go...we have no need for nat, so we did the whole nat (inside) 0 0 0 thing, so traffic gets out. then to get responses back in, applied an access-li...
we have tried similar things, and it appears that going out is fine, but pix doesn't let traffic back in to inside hosts. what about a static (outside, inside) translation? is that a valid option?
