Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm trying to configure a Pix 506E for a single network to allow RDP to the server. The Pix outside interface is a public IP that conects to a router managed by AT&T. The Ip address is 12.146.x.x. The inside interface is set to 192.168.1.1. To all...
I need to configure point to point serial connections on 3 routers. One is a 2811 and the other 2 are 2801's. The Point to point lines are in place and are terminated with Kentrox 656 CSU/DSU's at each location. I was thinking of using ppp authentic...
that doews help, thanks, however, one other question, the 2811 has 2 serial WAN interface cards but shows 3 serial interfaces: s0/0/0, s0/1/0, and s0/2/0, is the s0/0/0 a logical interfaces and if so, what is it used for?
