Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on a virtual Cisco WLC 9800 setup.The management interface is configured on GigabitEthernet1 with an IP address used for both management and data traffic.I have configured three SSIDs, and the site operates in Flex mode.Two of these SSID...
Hi,I have a Cisco 9105 Access Point connected to a WLC 9800. The AP successfully joins the controller, and I created four SSIDs. However, none of the SSIDs are being broadcast, they do not appear on any client devices.I verified the RF status; both 2...
I just want to test whether the laptop should always connect using 802.11ax or if it can revert to 802.11ac.I tried many times, but it only connects with Wi-Fi 6 (802.11ax) the first time.After disconnecting, it always reconnects using Wi-Fi 5 (802.1...
Hello,Thank you for your reply. At first, I was able to connect using Wi-Fi 6, but after disconnecting, it reverted to Wi-Fi 5. I did not move the PC or change the location of the AP.Here are the results of my tests:WLC#show wireless client mac E0:2...
Hello,I updated the Intel driver to the latest version (23.160.0.4) and upgraded the WLC to version 17.15.3.The issue still persists.Are you using the same AP model (9105AXI-I) or a different one?
Hi Community,I am using a Cisco vWLC 9800 with a Cisco 9105AXI-I AP. My phone connects with Wi-Fi 6 (802.11ax) successfully, but my laptop connects only with Wi-Fi 5 (802.11ac), even though it has an Intel(R) Wi-Fi 6 AX201 160MHz adapter.I have alrea...
