Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all;I have a used 2610 which I did a factory reset on. I am able to get into the IOS and edit/change the config.However after editing and trying to save using the command:copy run start I get prompted to save the config to a file name/location wh...
Hi all;I became aware of this advisory and wonder if a patch/update is appplicable or necessary.I have two 2600 series routers running 12.x vers. Here's excerpts from both:Router 1.IOS (tm) C2600 Software (C2600-I-M), Version 12.2(13)T5, RELEASE SO...
Edison;Thanks for the reply. Yes my register was 0x2142 but I did the "config-register 0x2102" and then was able to copy the running config to the startup config.I do have another ?. I did type in a time offset command for my timezone but after reb...
Hi;They are used for private "inside" IP addressing. Then if you require any outside access, one can NAT a public IP over to one of the private side IP addresses.This way outsiders can only ping/see your public IP address and have no idea what devic...
