Here is my configuration. I can ping from the Router out to the internet. From the LAN I can ping the "inside" port and the "outside" port, but nothing past that. I also have no other access (web, smtp, etc). I am new to this device and zone bas...
Cisco Universe, I would like to setup a redundant VPN connection to one of my vendors via a second ISP. Both ISP's terminate at a load balancer with the ASA being accessible with public IP addresses. The remote termination would be the same I...
I added this line to my config and my certificate error went away and I was able to connect just fine.ssl trust-point ASDM_TrustPoint0 outsideHope this helps,Rich
Here is what I have configured currently:!interface Vlan1 description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$$FW_INSIDE$ ip address 10.10.10.1 255.255.255.0 zone-member security in-zone ip tcp adjust-mss 1452interface FastEthernet4 description $FW_OUTSI...
Negative.abc-FW#ping 192.168.1.231 source 10.10.10.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.1.231, timeout is 2 seconds:Packet sent with a source address of 10.10.10.1 .....Success rate is 0 percent (0/5)abc-FW#
From the 2811 (1.231) router I can ping inside the 10.10.10.0/24 network, just not the other way around.perim2811#ping 10.10.10.2Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.10.10.2, timeout is 2 seconds:!!!!!Success rate is 100...