Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day to everyone.I have two Cisco ASA running on FPR2130 assembled into a balancing group, for example:vpn-gw1.example.comvpn-gw2.example.comgeneral address vpn.example.com.Firmware version 9.18.3.56Anyconnect 4.10.07062At the moment, all our emp...
Hi! I have two CIsco Asa versions 9.18.2 combined into a balancing group. For example:FQDN of the first node vpn-gw1.example.comFQDN of the second node vpn-gw2.example.comGeneral address vpn.example.comWhen setting up multi-factor authentication SAML...
Hello everyone and thank you so much for your answers, I was helped by updating the cisco asa software version to 9.19.1.24, now on 9.19.1.28 it also works without problems, hope it helps someone
Hi, thanks for the reply.I probably misunderstood the meaning of Load Balancing SAML. I thought that the functionality of using a single Load Balancing Group address in the Base Url would appear.Most likely, it meant simply distributing SAML authenti...
Hi, thanks for the link, I recently specifically updated my Cisco Asa to version 9.18.2, since Saml Load Balancing support appears in versions older than 9.17.1 - based on Release Notes. But the update did not give a result. Therefore, I decided to w...
