Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have approx 35 L2 switches connecting via Trunks to one 6513 that has the MSFC2. I want to take the customer away from this flat bridged network. In building a true Core, in best practices when do you move away from a L2 Core into a L3 core because...
I need to know the design best practices for using a L2 Core vs L3 core because of excessive peering from the IGP. If OSPF and EIGRP have different recommendations please include.Thank you!!John
Currently I have a remote site that has an internal ip address of 192.168.1.0/24. There are a few clients from this net that connect to our HQ using VPN client software and terminate on a PIX 501. The problem is they need to connect to boxes that are...
Have you noticed a significant increase in CPU, Interface counters (errors), buffers overflows...Are you running any baseline products so you can see if traffic has increased? Sounds like routing is ok because everything is directly connected. I tend...
The settings in the Hyper Terminal need to be set correctly; otherwise, "strange-looking" or garbage characters may show up on the screen. When setting up the connection, use the following settings:Bits per sec : 9600 Data bits : 8 Pari...
ACL 101 blocks everything except SMTP by a implied deny all at the end of every access-listSecond, your acl 100 is that a type-o? you can not apply multiple acls on the same interface one in and one out.Good luck.
