Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello again Folks,I posted here a few days ago (Pls help a 'Newbie', 27th November) and thanks to the prompt reply, I have now sucessfully configured my first Aironet 1200!I have another five to set up (for the same site) and I am now considering the...
Hello folks,I am trying to configure a 1200 - straight out of the box, so factory defaults (no radio on, set to receive IP from a DHCP server etc.).Our newtwork guy who would normally install such kit resigned with very short notice and took all info...
Scott,No problem about 'dropping the ball' - I didn't expect any more help from you unless I asked for it... The advise you gave me was enough to point me in the right direction and prevent any 'bad practice' situations. I know what you mean about ye...
Update...Scott,Just to let you know... All seven AP's are working in harmony with total blanket coverage of my site and seamless roaming. Thanks for all your help in pointing me up in the right direction!Best regards,Duncan Grant
Scott,Again, thanks very much for a speedy and informative reply!. I am not back on the job site until Monday, so obviously I won't be able to continue with the installation until then... If by Monday night I have any further problems, I'll post here...
Scott,Your my man! - I entered the commands you suggested and I am now in the GUI - I'll have a go at the rest myself, but if I get stuck again, I'll post back here...I did search Cisco with a similar search criteria to the one you suggested before p...
Thanks for the prompt reply Scott...I will try your suggestions. I am actually configuring the AP on my service laptop, which is running XP Pro with a McAfee firewall - I just switch this out when configuring devices that upset it!FYI (and not wishin...
