Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Sure can. But it is done via a FREE application called MRTG run on a separate PC. MRTG can show a multitude of information about each port, VLAN information, switch engine health statistics, etc. If you understand about CIsco MIBs, you can get MRTG...
If you can "touch" your remote server (or have someone remotely do so) enable WINS Replication on both your server and the remote server. Then force an immediate replication between the two servers and schedule future replications to occur during n...
From your answer about 50 clients, I assume that you are using DHCP. Settings are available in just about every DHCP server installation to set the primary and secondary DNS servers. So you only have to make one or two line entries at your server a...
