Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using an 851W configured with WPA-PSK and TKIP. I am getting an awful lot of messages in the log stating that a client has disassociated because it was leaving the BSSID, then the client immediately reconnects. I have duplicated this behavior wi...
I am using an 851W configured with WPA-PSK and TKIP. I am getting an awful lot of messages in the log stating that a client has disassociated because it was leaving the BSSID, then the client immediately reconnects. I have duplicated this behavior wi...
I am going to get a contract on it this week or the next. If and when they get it figured out, I will definitely post back the solution. Hopefully it's just a configuration thing and I can save someone else a little time and money! Anyway, thanks aga...
I have verified that the WPA keys match. I have not been seeing any authentication failures in the log, however today I see an authentication failure from one of my laptops at a time when the machine was 15 miles away, and didn't have the wireless ca...
I have not been able to get Commview to work with my client adapters. I am very interested in this "every 12 minutes" phenomenon, though, which continues. Do you think that if I buy a SMARTNet contract for this thing that Cisco will figure it out? I'...
I have used Kismet and seen the occasional "deauthenticate/disassociate flood" but not since I axed the Intel adapters and installed Aironet cardbus cards in both laptops. I am going to install Commview and will post back the results. Thanks again fo...
My 851W has only one antenna. It is the directly attached antenna that comes with the router, although I tried with a small omni with a 4 ft cable and the results were no different. The behavior occurs no matter whether the client is right next to th...
