Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the need to limit bandwidth used for a weekly copy job between our Production environment and our DR environment. We have a low CIR on our DR environment, so I would like to keep the bandwidth as low as possible between the sites to ensure th...
Hello-I am charged with configuring a PIX 515 (running v6.3.5) to allow inbound access to multiple web servers as well as FTP servers. My ip addressing is as follows:Outside- 12.x.x.x/28inside- 206.x.x.x/24All IP Addresses on the outside subnet are ...
Thanks for the info. Does the command that you wrote allow the transfer rate to burst to 8 Mbps? Am I reading that correctly? I do not want the transfer rate to go above 4 Mbps.Thanks again!
Thanks for all of the replies. I am going to go to work tonight and try to make this work, and I'll post back as soon as I get it up and running. Thanks again, you guys rule!
Ok, so what if you have multiple web servers on the inside interface of the PIX that need to be accessed from outside? My understanding of the command above is that you can only provide access to 1 internal IP address through that command, and exter...
