Hi, I have Cisco 2620 with a NM-4E module that I want to connect to a cable modem. Can I use the ip address dhcp cmd on the fastethernet port to dynamically acquire an IP from the ISP, and then connect multiple PCs to the NM-4E's 4 ethernet ports? If...

I have 2 ASAs in transparent mode, with multiple contexts, active/active config. I do not want to load balance. Do I need to define that in the system exec space?Also, I want to enable telnet to both ASAs. I've configured an IP to the primary ASA's a...

I'm trying to setup a 2514 to connect to an ISP through a cable modem. I'm running c2500-io-l.122-32 IOS, here are my configs:ip dhcp excluded-address 192.168.100.1 192.168.100.10ip dhcp pool Internal-DHCPimport allnetwork 192.168.100.0 255.255.255....