Hi everybody,I´m studying for the DCCOR and I´m little bit stuck with EEM Applets.I do understand the whole concept, but it is not clear to me for what the action "event-default" is needed?Can someone explain this to me please? In documentaiton I fou...
Hi everybody,I have a couple of questions regarding to understand the Infra VLAN:Why do all Leafs have the same IP on their Infra-VLAN SVI?Why do Spines don´t have such an Infra-VLAN SVI at all?Why is the Infra-VLAN configured on the Leaf (local VLAN...
Hi everybody,maybe someone here can help me understanding this.I try to do an ELAM on one of my Leaf Nodes (93180YC-EX) with the following settings: debug platform internal tah elam asic 0
trigger init in-select 6 out-select 1
set outer ipv4 dst_ip 1...
Hi,as @mabushei already explained, this is done via the identifier in the VXLAN header, as you can also see in this picture.Each Tenant, and it´s coponents like VRFs, BD, EPGs, have uniquie identifier, which map to a certain VXLAN Segment and to the ...
Hello Chris,first of all thank you very much for your thorough explaination.Yes, you were right about the part with the PI-VLAN on the Leaf and the Infra VLAN of the APIC.But what I don´t understand is, why is the Infra VLAN mapped to a PI-VLAN on th...
Thanks Joe!The second point you mention was causing the problem.There is a L3Out on another Leaf, where the paket entered the fabric AND the host I was trying to monitor was connected per VPC to this same leaf. So the paket went only to this leaf and...
