Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been passed a problem from a client trying to connect to a Remotely Anywhere server through a PIX/525.Remotely Anywhere is a remote control application that uses HTTP over TCP/2000. This port is open and theres no inspect enabled. From the con...
Hi .. i'm trying to restrict access to a modem attached to the aux port (2065)of a 2600.. i've created an IP based permit NAR with the AAA Client, port:2065, * .. which if i read correctly should give rev telnet access to just #.#.#.# 2065.when i app...
Hi ..Using ACS I'm trying to limit reverse telnet access to a modem which will later be used by TTYredirector. I want the users to only have access to the modem. We are on 3.01 ACS (yeah I know old) ..When I use the Network Access restrictions with...
is there a way to debug certain traffic ? eg one host to another.in IOS you can write an acl and debug against it. just wondering if theres a pix equiv.
Hi .. i kind of have this working enough to solve my issue but as i'm a newbie with pix i just wanted to run it past you guys.pix with 3 interfaces. inside, network1, network2. i'm trying to achieve :translate all traffic from inside to network 1.no...
your a star .. i had assumed as the NAR was IP based that the port reflected the IP port not the router assigned tty ..putting tty65 in the NAR has resolved my problem.
Arul .. thanks for your reply. I am running 7.2 s/w which seems to no longer have the 'debug packet' option.i found this http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008063b408.html#wp1063796which helps a litt...
