Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This sandbox is supposed to support netconf and restconf. SSH on port 22 and Netconf on port 830 are working but restconf on 443 is not. Using postman it appears that a nginx (reverse proxy?) is not forwarding the packets but returning a 404 NOT FOUN...
I've been attempting to use the AppDynamic sandbox occasionally over the past couple months. Each time I try to use it, I find that the services on the VMs are slow to start up or time out. For example, on the AppD controller, the published access fo...
@bigevilbeard I had already moved on to the reserved one earlier today and that worked. I had used the always-on for restconf in the past and thought that it still mentioned it supported this in the sandbox description but I must have glossed over th...
I think that this looks ok, but without a reservation and without seeing the other VMs that are configured to use this host/cluster, it's still possible that there is not enough resources at times for all the VMs. You would have to go into the report...
Here's a performance update.
I had to take a break from the sandbox until about 5:00 MDT.
3/24/2023 5:02:45 PM Controller and App VM working fast.3/24/2023 5:56:45 PM The controller is no longer responding to HTTP (http://10.10.20.2:8090/controller/)...
@ zowu You have not indicated that you made any change, but I reserved the lab again about 25 min ago, and in the past 25 min I have been able to progress to the same point that took 3-4 hours in previous attempts. It's very speedy now. I hope that t...
Thanks, @ zowu. I saw those resources in the lab interface. You're right, that should be enough, but if the host or cluster is oversubscribed, the VM wouldn't be getting it's full share of 8 vCPUs and might be stalled waiting for vCPU time slices. I'...
